Claros Water Intelligence System: Instrument Management Claros Connector

Claros Connector

Overview
Downloads
Accessories

Help

Add MSM to your existing controllers:
With the Claros Connector, you can now enable Mobile Sensor Management on any Claros-enabled sensor connected to an existing SC200/SC1000. The Claros Connector serves as an edge device: it is installed next to the SC200/SC1000 and connected to enable MSM. No change to your existing setup, just the added value that MSM provides.

Mobile Sensor Management (MSM) is part of Claros, the Water Intelligence System from Hach. It is a web-based software solution developed to address critical challenges that affect your instrument measurements and the quality of your data.

Are you worried about downtime and maintenance? How do you know maintenance is done correctly and on-time?
Mobile Sensor Management includes Prognosys Predictive Diagnostics that allows you to be proactive in your maintenance and avoid unexpected downtime. The software alerts you to upcoming and overdue maintenance by monitoring internal components and service requirements. MSM also includes guided maintenance workflows to ensure maintenance is not only done on time, but correctly.

How do you get notifications and measurement data from remote facilities where there is no operator?
Mobile Sensor Management gives you complete visibility on the status of your instruments. Measurement data, maintenance indicators, and device status is available real-time on any web-enabled device. In addition to the notifications within the software, you’ll get email reminders when maintenance is upcoming, overdue, or a device stops reading. Managing your remote plant has never been easier.

Do you struggle comparing lab and process measurements and question which reading is correct?
Mobile Sensor Management simplifies calibration between lab and process instruments by allowing you to send laboratory measurements to your connected process instruments. No need to pull sensors out of the process for calibration – simply take a grab sample for analysis and send the value from your spectrophotometer to your process sensor for calibration corrections.

Print PDF Page